Zyxel-communications 70 Series Manual do Utilizador descarregar pdf (Página 617)

100

101

ZyWALL 5/35/70 Series User’s Guide

617 Chapter 47 Firmware and Configuration File Maintenance

47.3.8 GUI-based TFTP Clients

The following table describes some of the fields that you may see in GUI-based TFTP clients.

Refer to Section 47.3.5 on page 615 to read about configurations that disallow TFTP and FTP

over WAN.

47.3.9 Backup Via Console Port

Back up configuration via console port by following the HyperTerminal procedure shown

next. Procedures using other serial communications programs should be similar.

1 Display menu 24.5 and enter “y” at the following screen.

Figure 368 System Maintenance: Backup Configuration

2 The following screen indicates that the Xmodem download has started.

Figure 369 System Maintenance: Starting Xmodem Download Screen

3 Run the HyperTerminal program by clicking Transfer, then Receive File as shown in the

following screen.

Table 232 General Commands for GUI-based TFTP Clients

COMMAND DESCRIPTION

Host Enter the IP address of the ZyWALL. 192.168.1.1 is the ZyWALL’s default IP

address when shipped.

Send/Fetch Use “Send” to upload the file to the ZyWALL and “Fetch” to back up the file on your

computer.

Local File Enter the path and name of the firmware file (*.bin extension) or configuration file

(*.rom extension) on your computer.

Remote File This is the filename on the ZyWALL. The filename for the firmware is “ras” and for

the configuration file, is “rom-0”.

Binary Transfer the file in binary mode.

Abort Stop transfer of the file.

Ready to backup Configuration via Xmodem.

Do you want to continue (y/n):

You can enter ctrl-x to terminate operation any

time.

Starting XMODEM download...

1 2 ... 612 613 614 615 616 617 618 619 620 621 622 ... 806 807

Comentários a estes Manuais

Sem comentários

Zyxel-communications 70 Series Manual do Utilizador Página 617

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Zyxel-communications 70 Series