Zyxel-communications Internet Security Gateway ZyWALL 100 Manual do Utilizador descarregar pdf (Página 58)

ZyWALL 100 Internet Security Gateway

WAN Setup 5-5

FIELD DESCRIPTION DEFAULT

AT Response String:

CLID (Calling Line

Identification)

Enter the keyword that precedes the CLID (Calling Line Identification)

in the AT response string. This lets the ZyWALL capture the CLID in

the AT response string that comes from the WAN device. CLID is

required for CLID authentication.

NMBR =

Called Id Enter the keyword preceding the dialed number. TO

Speed Enter the keyword preceding the connection speed. CONNECT

Table 5-3 Advanced WAN Port Setup — Call Control Parameters

FIELD DESCRIPTION DEFAULT

Call Control

Dial Timeout (sec) Enter a number of seconds for the ZyWALL to keep trying to set up

an outgoing call before timing out (stopping). The ZyWALL times

out and stops if it cannot set up an outgoing call within the timeout

value.

60 seconds

Retry Count Enter a number of times for the ZyWALL to retry a busy or no-

answer phone number before blacklisting the number.

0 to disable

the blacklist

control

Retry Interval

(sec)

Enter a number of seconds for the ZyWALL to wait before trying

another call after a call has failed. This applies before a phone

number is blacklisted.

Drop Timeout

(sec)

Enter a number of seconds for the ZyWALL to wait before dropping

the DTR signal if it does not receive a positive disconnect

confirmation.

20 seconds

Call Back Delay

(sec)

Enter a number of seconds for the ZyWALL to wait between

dropping a callback request call and dialing the co-responding

callback call.

15 seconds

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 355 356

Comentários a estes Manuais

Sem comentários

Zyxel-communications Internet Security Gateway ZyWALL 100 Manual do Utilizador Página 58

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Zyxel-communications Internet Security Gateway ZyWALL 100