Zyxel-communications P-334W Manual do Utilizador descarregar pdf (Página 141)

100

101

Prestige 334W User’s Guide

WAN Screens 9-11

Table 9-5 WAN: IP

LABEL DESCRIPTION

Allow between WAN

and LAN

Select this check box to forward NetBIOS packets from the LAN to the WAN and

from the WAN to the LAN. If your firewall is enabled with the default policy set to

block WAN to LAN traffic, you also need to enable the default WAN to LAN firewall

rule that forwards NetBIOS traffic.

Clear this check box to block all NetBIOS packets going from the LAN to the WAN

and from the WAN to the LAN.

Allow Trigger Dial Select this option to allow NetBIOS packets to initiate calls.

Apply

Click Apply to save your changes back to the Prestige.

Reset

Click Reset to begin configuring this screen afresh.

9.6 Configuring WAN MAC

To change your Prestige’s WAN MAC settings, click WAN, then the WAN MAC tab. The screen appears

as shown.

Figure 9-6 MAC Setup

The MAC address screen allows users to configure the WAN port's MAC address by either using the factory

default or cloning the MAC address from a computer on your LAN. Choose Factory Default to select the

factory assigned default MAC Address.

Otherwise, click Spoof this computer's MAC address - IP Address and enter the IP address of the

computer on the LAN whose MAC you are cloning. Once it is successfully configured, the address will be

copied to the rom file (ZyNOS configuration file). It will not change unless you change the setting or upload

a different ROM file.

It is recommended that you clone the MAC address prior to hooking up the WAN Port.

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 495 496

Comentários a estes Manuais

Sem comentários

Zyxel-communications P-334W Manual do Utilizador Página 141

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Zyxel-communications P-334W