ZyXEL Communications 2002 Series Guia do Utilizador Página 124

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 123
VES-1000 Series Ethernet Switch
12-10 VDSL-Related Commands
Table 12-6 Ethernet Status Counters
COUNTER MEANING
LATE_COL The number of times that a collision was detected on a particular interface later than 512 bit-
times into the transmission of a packet.
EXC_COL A count of frames for which transmission failed due to excessive collisions. Excessive collision
is defined as the number of maximum collisions before the retransmission count is reset.
MACRX_ERR This counter contains the number of frames received that were less than 64 bytes. These
frames are discarded.
CS_ERR The number of times that the carrier sense condition was lost or never asserted when
attempting to transmit a frame on a particular interface.
FTL_ERR This counter contains the number of frames received that were more than maximum length
(1536 bytes). These frames are discarded.
FCS_ERR Frame Check Sequence Errors.
OTO A count of data and padding octets of frames that are successfully transmitted.
ORO A count of data and padding octets of frames that are successfully received.
BCF A count of frames that are successfully received and are directed to the broadcast group
address.
RXPAUS The number of received PAUSE packets.
TXPAUS The number of PAUSE packets transmitted.
TXBCNT This counter indicates the number of valid data frames that have been transferred over the
transmit channel.
RXBCNT This counter indicates the number of valid data frames that have been transferred over the
receive channel.
TX_DEF A count of frames for which the first transmission attempt was delayed because the Ethernet
media was busy.
12.3.2 Clear Ethernet Counters
vdsl enet clear chan-id
This command clears the Ethernet Counters of VES-1000 Series switch and the VDSL modem (if connected to
the VES-1000 Series switch).
12.3.3 VDSL Enet Speed Command
vdsl enet speed chan-id (lt|nt) (speed)
Type this command to set the Ethernet port speed of the VES-1000 Series switch (with “lt”) or VDSL subscriber
modem (with “nt”). Speed parameters are explained in the following table.
Vista de página 123
1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 160 161

Comentários a estes Manuais

Sem comentários