ZyXEL Communications A-6000 Guia do Utilizador descarregar pdf (Página 27)

A-6000 High Speed, Long Range Ethernet Wireless Bridge

Initial Setup 3-1

Chapter 3 Initial Setup

This chapter explains how to perform the initial A-6000 setup and gives an overview of WEB menus.

3.1 Network Topology Planning

The A-6000 is designed to build up a secure Inter-building wireless communication system between offices’ Ethernet

connection. Your A-6000 can be applied for Point to Point (PTP) application. The A-6000 consists of basestation unit

(BU) and remote unit (RU). The A-6000 basestation unit can communicate with one A-6000 remote unit for PTP

connection on the air. The network topology for PTP wireless connection is shown below.

Figure 3-1 A-6000 Networking Topology

The networking operation mode of A-6000 is bridge mode. The bridge mode supports only the PTP connection. You

have to appropriately configure your A-6000 Basestation unit and Access Client for normal operation according to

your network topology and requirements before physical installation.

3.2 Configure A-6000

This guide shows you the default factory configuration of A-6000 and how to configure the A-6000 for appropriate

operation at the first time. See the User’s Guide for configuration details.

3.2.1. Default Configuration

The A-6000 is shipped with following factory default configurations:

Table 3-1 Default configuration

BU RU

LAN IP 192.168.1.1 192.168.1.1

Subnet Mask 255.255.255.0 255.255.255.0

Wireless ESSID Wireless Wireless

Username/Password admin/1234 admin/1234

Note: before operation please change the RU LAN IP setting to 192.168.1.2 to make a successful telnet or web page access.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 45 46

Sem comentários

ZyXEL Communications A-6000 Guia do Utilizador Página 27