ZyXEL Communications NXC5200 - V2.20 Manual do Utilizador descarregar pdf (Página 21)

ZyXEL Communications Corp. Proprietary & Confidential Information

www.zyxel.com

 The console session displays “Firmware received” after the FTP file transfer is

complete. Then you need to wait while the device recovers the firmware (this may

take up to 4 minutes).

 The message here might be “ZLD-current received”. Actually, it is equivalent to

“Firmware received”.

 The console session displays “done” when the firmware recovery is complete. Then

the device automatically restarts.

 The username prompt displays after the device starts up successfully. The firmware

recovery process is now complete and the device is ready to use.

 If one of the following cases occurs, you need to do the “firmware recovery process”

again. Note that if the process is done several time but the problem remains, please

collect all the console logs and send to ZyXEL for further analysis.

 Refer to Step 1 “Restore the Recovery Image” and if there is similar case, the

process must be performed again.

 One of the following messages appears on console, the process must be

performed again.

 /bin/sh: /etc/zyxel/conf/ZLDconfig: No such file

 Error: no system default config file, system configuration stop!!

1 2 ... 16 17 18 19 20 21

Sem comentários

ZyXEL Communications NXC5200 - V2.20 Manual do Utilizador Página 21