Zyxel-communications P-2802H(W)(L)-I Series Manual do Utilizador descarregar pdf (Página 41)

Chapter 1 Introducing the ZyXEL Device

P-2802H(W)(L)-I Series User’s Guide

Refer to the Quick Start Guide for information on hardware connections.

1.6 The RESET Button

You can use the RESET button at the back of the device to turn the wireless LAN off or on.

You can also use it to activate OTIST in order to assign your wireless security settings to

wireless clients. If you forget your password or cannot access the web configurator, you will

need to use the RESET button to reload the factory-default configuration file. This means that

you will lose all configurations that you had previously and the password will be reset to

“1234”. You can also use the

1.6.1 Using The Reset Button

1 Make sure the POWER LED is on (not blinking).

2 Do one of the following.

To turn the wireless LAN off or on, press the RESET button for one second and release

it. The WLAN LED should change from on to off or vice versa. (“W” models only)

To activate OTIST in order to assign your wireless security settings to wireless clients,

press the RESET button for three seconds and release it. The WLAN LED should flash

while the device uses OTIST to send wireless settings to OTIST clients. (“W” models

only)

WLAN Green On Your device is ready, but is not sending/receiving data

through the wireless LAN.

Blinking Your device is sending/receiving data through the wireless

LAN.

None Off The wireless LAN is not ready or has failed.

DSL Green On Your device has a DSL connection.

None Off The DSL link is down.

INTERNET Green On Your device has an IP connection but no traffic.

Your device has a WAN IP address (either static or assigned

by a DHCP server), PPP negotiation was successfully

completed (if used) and the DSL connection is up.

Blinking Your device is sending or receiving IP traffic.

Red On Your device attempted to make an IP connection but failed.

Possible causes are no response from a DHCP server, no

PPPoE response, PPPoE authentication failed).

None Off Your device does not have an IP connection

PHONE 1, 2 Green On A SIP account is registered for the phone port.

Blinking A telephone connected to the phone port has its receiver off

of the hook or there is an incoming call.

None Off The phone port does not have a SIP account registered.

Table 3 LEDs (continued)

LED COLOR STATUS DESCRIPTION

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 417 418

Sem comentários

Zyxel-communications P-2802H(W)(L)-I Series Manual do Utilizador Página 41