ZyXEL Communications GS3700 Series Guia do Utilizador Página 344

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 416
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 343
Chapter 42 Access Control
GS3700/XGS3700 Series User’s Guide
344
42.3.5 Configuring SNMP Trap Group
From the SNMP screen, click Trap Group to view the screen as shown. Use the Trap Group
screen to specify the types of SNMP traps that should be sent to each SNMP manager.
Figure 228 Management > Access Control > SNMP > Trap Group
The following table describes the labels in this screen.
Username Enter the username to be sent to the SNMP manager along with the SNMP v3 trap.
Note: This username must match an existing account on the Switch (configured in the
Management > Access Control > SNMP > User screen).
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 177 Management > Access Control > SNMP (continued)
LABEL DESCRIPTION
Table 178 Management > Access Control > SNMP > Trap Group
LABEL DESCRIPTION
Trap Destination
IP
Select one of your configured trap destination IP addresses. These are the IP addresses of
the SNMP managers. You must first configure a trap destination IP address in the SNMP
Setting screen.
Use the rest of the screen to select which traps the Switch sends to that SNMP manager.
Type Select the categories of SNMP traps that the Switch is to send to the SNMP manager.
Options Select the individual SNMP traps that the Switch is to send to the SNMP station. See
Section 42.3.3 on page 339 for individual trap descriptions.
The traps are grouped by category. Selecting a category automatically selects all of the
category’s traps. Clear the check boxes for individual traps that you do not want the
Switch to send to the SNMP station. Clearing a category’s check box automatically clears
all of the category’s trap check boxes (the Switch only sends traps from selected
categories).
Vista de página 343
1 2 ... 339 340 341 342 343 344 345 346 347 348 349 ... 415 416

Comentários a estes Manuais

Sem comentários