ZyXEL Communications Prestige 642M series Guia do Utilizador Página 78

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 77
Prestige 642 ADSL Internet Access Router
Remote Node TCP/IP Configuration 5-1
Chapter 5
Remote Node TCP/IP Configuration
This chapter shows you how to configure the TCP/IP parameters of a remote node.
A typical LAN-to-LAN application is to use your Prestige to connect a branch office to the headquarters, as
depicted in the following diagram.
5.1 LAN-to-LAN Application
Figure 5-1 TCP/IP LAN-to-LAN Application
For the branch office, you need to configure a remote node in order to dial out to the headquarters.
Additionally, you may also need to define static routes if some services reside beyond the immediate
remote LAN.
5.1.1 Editing TCP/IP Options
Follow the steps below to edit
Menu 11.3 - Remote Node Network Layer Options
shown next.
In Menu 11.1, move the cursor to the
Edit IP/IPX/Bridge
, then press the space bar to toggle and set the
value to
Yes
. Press
[ENTER]
to open
Menu 11.3 - Network Layer Options
.
There are two versions of menu 11.3 for the P642, depending on whether you chose
VC-based
or
LLC-
based
Multiplexing
in menu 11.1.
VC-Based Multiplexing
Remember that for
VC-based
multiplexing, by prior mutual agreement, a protocol is assigned a specific
virtual circuit, e.g., VC1 will carry IP, VC2 will carry IPX etc.
Vista de página 77
1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 154 155

Comentários a estes Manuais

Sem comentários