Zyxel-communications P-334WHD Manual do Utilizador descarregar pdf (Página 109)

P-334WHD User’s Guide

Chapter 6 WAN 109

Allow between LAN

and WAN

Select this check box to forward NetBIOS packets from the LAN to the WAN

and from the WAN to the LAN. If your firewall is enabled with the default policy

set to block WAN to LAN traffic, you also need to enable the default WAN to

LAN firewall rule that forwards NetBIOS traffic.

Clear this check box to block all NetBIOS packets going from the LAN to the

WAN and from the WAN to the LAN.

Allow Trigger Dial Select this option to allow NetBIOS packets to initiate calls.

Dialup PPP Options

PPP Encapsulation Select CISCO PPP if your dial-up connection uses Cisco PPP encapsulation.

Otherwise select Standard PPP.

Enable Compression Select this check box to turn on stac compression.

Call Control

Dial Timeout (sec) Type the number of seconds for the ZyXEL Device to try to set up an outgoing

call before timing out (stopping).

Retry Count When the ZyXEL Device calls a number, and there is no reply, type the

number of times the ZyXEL Device should keep trying to call the number.

Retry Interval (sec) Type the number of seconds for the ZyXEL Device to wait before trying

another call after a call has failed.

Drop Timeout (sec) Type the number of seconds for the ZyXEL Device to wait before hanging up

the call if it does not receive a positive disconnect confirmation.

Apply Click Apply to save your changes back to the ZyXEL Device.

Reset Click Reset to begin configuring this screen afresh.

Table 42 WAN > Advanced

LABEL DESCRIPTION

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 299 300

Sem comentários

Zyxel-communications P-334WHD Manual do Utilizador Página 109