ZyXEL Communications ZyWALL 70 Informações Técnicas descarregar pdf (Página 17)

ZyWALL 1050 Support Notes

ZyWALL70 local and remote policies are 192.168.2.0 and 192.168.1.0 and the traffic

from 192.168.2.X subnet to 192.168.1.X subnet will go through the VPN tunnel to the

remote site as predefined. The ZyWALL1050 local and remote policies must be reverse to

the ZyWALL70’s settings, otherwise the tunnel will not be built up.

7) Check whether the IPSec proposal on both sites is the same and the configuration is done

on both sites.

8) The ZyWALL1050 VPN is a route-based VPN, this means the VPN tunnel can be an

interface to route the VPN traffic. Thus, we need to configure a policy route for VPN

traffic from the local subnet to the remote subnet after configuring the VPN gateway and

the connection (phase1 and phase2). The purpose for this policy route is to tell the

ZyWALL1050 to send the traffic to the VPN tunnel when the traffic goes from the local

subnet to the destination that is in a remote subnet. Switch to Configuration > Policy >

Route > Policy Route and add a new policy route, the source and destination address are

the local and remote subnet and the Next-Hop type is a VPN tunnel. Then choose the

corresponding VPN connection rule from the VPN tunnel drop down menu. Now, the VPN

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 297 298

Sem comentários

ZyXEL Communications ZyWALL 70 Informações Técnicas Página 17