ZyXEL Communications ZyWALL 70 Informações Técnicas descarregar pdf (Página 271)

ZyWALL 1050 Support Notes

271

management tasks in GUI?

There may be several reasons for ZyWALL 1050 to redirect you to login page when you are

doing configuration.

1. Admin user’s re-auth time (force re-login time) has reached. The default time value is

24hours.

2. Admin user’s lease time has been reached. The default time value is 24hours.

3. You are trying to login ZyWALL 1050 using other remote management client (telnet or

ssh…etc) after you logged in ZyWALL 1050 using a web browser.

4. PC’s IP address has changed after your previous login. The re-login is required then.

A05. Why do I lose my configuration setting after ZyWALL 1050 restarts?

There may have two reasons:

1. If you configure ZyWALL 1050 from CLI. You must type CLI “write” to save the

configuration before rebooting. If you configure ZyWALL 1050 from GUI, any

configuration will be automatically saved.

2. ZyWALL 1050 might fail to apply the configuration using the startup-config.conf when

booting up. It might because the startup-config.conf is corrupted. If so, ZyWALL 1050 will

try to use the last boot up configuration file (lastgood.conf), which can boot up

successfully. Your settings will revert to the last boot up configuration.

A06. How can I do if the system is keeping at booting up stage for a long time?

There are two reasons if your ZyWALL 1050 boots up for a long time as below.

1. It might because you have many configuration on ZyWALL 1050. For example, you

configured over 500 VPN settings. Please connect to console and you can see which process

the system is processing at.

Note: If the system is processing ok, admin can connect to ZyWALL 1050’s ge1 port which is

with IP address 192.168.1.1 by default.

2. The ZyWALL 1050 may get firmware crashed. Generally, it may happen if power off

ZyWALL 1050 when it’s during firmware upgrading. For this case, admin could connect to

console and see the message as shown below (ensure your terminal baud rate is configured

1 2 ... 266 267 268 269 270 271 272 273 274 275 276 ... 297 298

Sem comentários

ZyXEL Communications ZyWALL 70 Informações Técnicas Página 271