ZyXEL Communications MAX218MW Guia do Utilizador descarregar pdf (Página 11)

Chapter 1 Introduction

WRE2205 User’s Guide

1.4 The WPS Button

The WPS button can be used to begin WiFi Protected Setup (WPS), reboot the WRE2205 while

keeping it’s configuration or reboot the WRE2205 to factory default configuration.

1.4.1 WiFi Protected Setup

Your WRE2205 supports Wi-Fi Protected Setup (WPS), which is an easy way to set up a secure

wireless network. WPS is an industry standard specification, defined by the WiFi Alliance.

WPS allows you to quickly set up a wireless network with strong security, without having to

configure security settings manually. Each WPS connection works between two devices. Both

devices must support WPS (check each device’s documentation to make sure).

Depending on the devices you have, you can either press a button (recommended) on the device

itself, or in its configuration utility or enter a PIN (a unique Personal Identification Number that

allows one device to authenticate the other) in each of the two devices. When WPS is activated on

Wi-Fi Blinking The WRE2205 is sending/receiving data through the wireless LAN.

Off The wireless LAN is not ready or the LED is turned off in the firmware.

Power On The WRE2205 is receiving power and functioning properly.

Blinking The WRE2205 is resetting to factory defaults.

Off The WRE2205 is not receiving power or the LED is turned off in the firmware.

WPS On This remains on for 5 minutes after a successful WPS connection has been

established.

Blinking The WRE2205 is waiting for another WPS device to connect.

Off There is no WPS connection established or the LED is turned off in the

firmware.

LAN On The WRE2205 has a successful 10/100MB LAN connection.

Blinking The WRE2205 is sending/receiving data through the LAN.

Off The LAN is not connected or the LED is turned off in the firmware.

Table 1 Front Panel LEDs and WPS Button (continued)

LED STATUS DESCRIPTION

Table 2 WPS Button Functions

ACTION RESULT

Push once or hold for

less than 5 seconds

The WRE2205 begins connecting to an AP via WPS. See Section

5.3 on page 32.

Push twice The WRE2205 begins connecting to a wireless client via WPS. See

Section 5.2 on page 29.

Hold for 5 to 10

seconds

The WRE2205 keeps its configuration and reboots.

Hold for more than 10

seconds

The WRE2205 resets its configuration to factory defaults and

reboots. See Section 2.3 on page 14.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 73 74

Comentários a estes Manuais

Sem comentários

ZyXEL Communications MAX218MW Guia do Utilizador Página 11

Comentários a estes Manuais