Zyxel-communications 5 Series Manual do Utilizador descarregar pdf (Página 145)

100

101

ZyWALL 5/35/70 Series User’s Guide

Chapter 7 Bridge Screens 145

7.4 Bridge Port Roles

Use the Port Roles screen to set ports as part of the LAN, DMZ and/or WLAN interface.

Ports 1~4 on the ZyWALL 5 and ZyWALL 35 ports can be part of the LAN, DMZ or WLAN

interface. The ZyWALL 70 has a separate (dedicated) LAN port, so ports 1~4 can be set as

part of the DMZ and/or WLAN interface.

To change your ZyWALL’s port role settings, click NETWORK > BRIDGE > Port Roles.

The screen appears as shown.

The radio buttons correspond to Ethernet ports on the front panel of the ZyWALL. On the

ZyWALL 70, ports 1 to 4 are all DMZ ports by default. On the ZyWALL 5 or ZyWALL 35,

ports 1 to 4 are all LAN ports by default.

Rapid Spanning Tree

Protocol Setup

Enable Rapid Spanning

Tree Protocol

Select the check box to activate RSTP on the ZyWALL.

Bridge Priority Enter a number between 0 and 61440 as bridge priority of the ZyWALL.

Bridge priority is used in determining the root switch, root port and

designated port. The switch with the highest priority (lowest numeric value)

becomes the root. If multiple devices have the lowest priority, the device

with the lowest MAC address becomes the root.

The lower the numeric value you assign, the higher the priority for this

bridge.

Bridge Priority determines the root bridge, which in turn determines Hello

Time, Max Age and Forward Delay.

Bridge Hello Time Enter an

interval (between 1 and 10) in seconds that the root bridge

waits before sending a hello packet.

Bridge Max Age Enter an interval

(between 6 and 40) in seconds that a bridge waits to

get a Hello BPDU from the root bridge.

Forward Delay Enter the length of time

(between 4 and 30) in seconds that a bridge

remains in the listening and learning port states. The default is 15 seconds.

Bridge Port This is the bridge port type.

RSTP Active Select the check box to enable RSTP on the corresponding port.

RSTP Priority

0(Highest)~240(Lowest)

Enter a number between 0 and 240 as RSTP priority for the corresponding

port. 0 is the highest.

RSTP Path Cost

1(Lowest)~65535(Highes

Enter a number between 1 and 65535 as RSTP path cost for the

corresponding port. 65535 is the highest.

Apply Click Apply to save your changes back to the ZyWALL.

Reset Click Reset to begin configuring this screen afresh.

Table 29 NETWORK > Bridge (continued)

LABEL DESCRIPTION

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 834 835

Comentários a estes Manuais

Sem comentários

Zyxel-communications 5 Series Manual do Utilizador Página 145

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Zyxel-communications 5 Series