Zyxel-communications 5 Series Manual do Utilizador descarregar pdf (Página 668)

100

101

ZyWALL 5/35/70 Series User’s Guide

668 Chapter 47 Firmware and Configuration File Maintenance

47.3.8 GUI-based TFTP Clients

The following table describes some of the fields that you may see in GUI-based TFTP clients.

Refer to Section 47.3.5 on page 666 to read about configurations that disallow TFTP and FTP

over WAN.

47.3.9 Backup Via Console Port

Back up configuration via console port by following the HyperTerminal procedure shown

next. Procedures using other serial communications programs should be similar.

1 Display menu 24.5 and enter “y” at the following screen.

Figure 409 System Maintenance: Backup Configuration

2 The following screen indicates that the Xmodem download has started.

Figure 410 System Maintenance: Starting Xmodem Download Screen

3 Run the HyperTerminal program by clicking Transfer, then Receive File as shown in the

following screen.

Table 248 General Commands for GUI-based TFTP Clients

COMMAND DESCRIPTION

Host Enter the IP address of the ZyWALL. 192.168.1.1 is the ZyWALL’s default IP

address when shipped.

Send/Fetch Use “Send” to upload the file to the ZyWALL and “Fetch” to back up the file on your

computer.

Local File Enter the path and name of the firmware file (*.bin extension) or configuration file

(*.rom extension) on your computer.

Remote File This is the filename on the ZyWALL. The filename for the firmware is “ras” and for

the configuration file, is “rom-0”.

Binary Transfer the file in binary mode.

Abort Stop transfer of the file.

Ready to backup Configuration via Xmodem.

Do you want to continue (y/n):

You can enter ctrl-x to terminate operation any

time.

Starting XMODEM download...

1 2 ... 663 664 665 666 667 668 669 670 671 672 673 ... 834 835

Comentários a estes Manuais

Sem comentários

Zyxel-communications 5 Series Manual do Utilizador Página 668

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Zyxel-communications 5 Series