Zyxel-communications NWA3550 Manual do Utilizador descarregar pdf (Página 322)

Appendix F Text File Based Auto Configuration

NWA3550 User’s Guide

322

" If adjacent APs use the same configuration file, you should leave out the

channel setting since they could interfere with each other’s wireless traffic.

Auto Configuration by DHCP

A DHCP response can use options 66 and 67 to assign a TFTP server IP address and a

filename. If the AP is configured as a DHCP client, these settings can be used to perform auto

configuration.

If this feature is enabled and the DHCP response provides a TFTP server IP address and a

filename, the AP will try to download the file from the specified TFTP server. The AP then

uses the file to configure wireless LAN settings.

" Not all DHCP servers allow you to specify options 66 and 67.

Manual Configuration

Use the following command to manually configure a TFTP server IP address and a file name

for the AP to use for auto provisioning whenever the AP starts up. See Section 25.1 on page

257 for how to access the Command Interpreter (CI).

Configuration Via SNMP

You can configure and trigger the auto configuration remotely via SNMP.

Table 100 Auto Configuration by DHCP

COMMAND DESCRIPTION

wcfg autocfg dhcp [enable |

disable]

Turn configuration of TFTP server IP address and

filename through DHCP on or off.

Table 101 Manual Configuration

COMMAND DESCRIPTION

wcfg autocfg server [IP]

[filename]

Specify the TFTP server IP address and file name from

which the AP is to download a configuration file whenever

the AP starts up.

1 2 ... 317 318 319 320 321 322 323 324 325 326 327 ... 343 344

Sem comentários

Zyxel-communications NWA3550 Manual do Utilizador Página 322