Zyxel-communications Omni TA128 Manual do Utilizador descarregar pdf (Página 115)

103

DTE Port 2 Call Control

To place a call through DTE port 2, use the ATDxxxx command.

If the Calling Party Number (the original address) is required in the

outgoing SETUP message, it can be pre-stored using the

AT&ZOI=xxxx command. Once the PPP connection is

established, the TA128 will indicate the connection message with

DTE speed as follows:

CONNECT 115200 PPP

Use ATV0, if numerical result code is required. An X.75 or V.120

can be placed after selecting the protocol using ATBnn.

By default, to answer a call through DTE port 2, the MSN(or

subaddress) must have been set using the AT&ZI5=xxxx

command and the number xxxx must be matched with the Called

Party Number (the destination address) of the incoming call. The

DTE port 2 Multi-Auto function will automatically identify the

protocol of the incoming call as PPP, X.75 or V.120.

Use ATS87.7=1 to enable the TA to route data calls to DTE port 2

if DTE port 1 is busy.

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 172 173

Sem comentários

Zyxel-communications Omni TA128 Manual do Utilizador Página 115