Zyxel-communications Omni TA128 Manual do Utilizador descarregar pdf (Página 125)

113

Since it is not intended for all users, the specifications and manual

for the multiplex mode will be available in a separate text file, and

will only be available in the electronic format upon request.

AT Command Descriptions

An AT Command is a command in asynchronous data format

issued by the computer to the TA through the asynchronous

computer-modem interface. AT Commands control the TA's

behavior and actions. To send an AT Command from a computer

to the TA, you must be running communication software and the

TA must be in the command state.

Exceptions to this are A/, A>, and +++. These commands are not

preceded by AT, or followed by any more characters:

• A/ - re-executes the last command once.

• A> - re-executes the last command once or repeats the last call

up to 9 times until aborted by pressing down on any key on the

keyboard or front panel or until a successful connection with a

remote TA has been made.

• +++ - is the escape sequence code that is entered in data state

to return the TA to command state. The TA will accept AT

commands only while it is in command state.

The AT command prefix may be typed in either upper ‘AT’ or

lower case ‘at’. Do not use a combination of upper and lower cases

in the prefix.

The following tables list all of the AT commands supported by the

TA128. An asterisk * following a command option or value

indicates that it is a default setting when the TA is shipped.

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 172 173

Sem comentários

Zyxel-communications Omni TA128 Manual do Utilizador Página 125