
17-6 Firmware and Configuration Maintenance
where “i” specifies binary image transfer mode (use this mode when transferring binary files), “host” is the
Prestige IP address, “get” transfers the file source on the Prestige (rom-0 name of the configuration file on
the Prestige) to the file destination on the computer and renames it config.rom.
TFTP GUI Clients
The following table describes some of the fields that you may see in some TFTP GUI clients.
Table 17-3 General Commands for TFTP GUI Clients
COMMAND DESCRIPTION
Host Enter the IP address of the Prestige. 192.168.1.1 is the Prestige’s default IP address
when shipped.
Send/Fetch Use “Send” to upload the file to the Prestige and “Fetch” to back up the file on your
computer.
Local File Enter the path and name of the firmware file (*.bin extension) or configuration file (*.rom
extension) on your computer.
Remote File This is the filename on the Prestige. The filename for the firmware is “ras” and for the
configuration file, is “rom-0”.
Binary Transfer the file in binary mode.
Abort Stop transfer of the file.
Refer to the TFTP and FTP over WAN Will Not Work When section to read about configurations that
disallow TFTP and FTP to work over WAN.
17.2.4 Backup Via Console Port
Backup configuration via console port by following the HyperTerminal procedure shown next. Procedures
using other serial communications programs should be similar.
Step 13. Display menu 24.5 and enter “y” at the following screen.
urenrjrjkvnm
Med
Cinema