
ZyXEL G-1000 v2 User’s Guide
116 Chapter 15 System Information and Diagnosis
15.2.2 Console Port Speed
Note: The console port is internal and reserved for technician use only.
You can set up different port speeds for the console port through Menu 24.2.2 – System
Maintenance – Console Port Speed. Your G-1000 v2 supports 9600 (default), 19200, 38400,
57600 and 115200 bps console port speeds. Press [SPACE BAR] and then [ENTER] to select
the desired speed in menu 24.2.2, as shown in the following figure.
Figure 64 Menu 24.2.2 System Maintenance: Change Console Port Speed
After you changed the console port speed on your G-1000 v2, you must also make the same
change to the console port speed parameter of your communication software.
15.3 Log and Trace
To get to the log and trace information:
1 Enter 24 to display Menu 24 – System Maintenance.
2 Enter 3 to display Menu 24.3 – Log and Trace.
3 From this menu you have one choice as shown in the next figure:
ZyNOS F/W Version Refers to the ZyNOS (ZyXEL Network Operating System) system firmware
version. ZyNOS is a registered trademark of ZyXEL Communications
Corporation.
Country Code Refers to the country code of the firmware.
LAN
Ethernet Address Refers to the Ethernet MAC (Media Access Control) of your G-1000 v2.
IP Address This is the IP address of the G-1000 v2 in dotted decimal notation.
IP Mask This shows the subnet mask of the G-1000 v2.
DHCP This field shows the DHCP setting of the G-1000 v2.
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC
to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
Table 49 Menu 24.2.1 System Maintenance: Information
FIELD DESCRIPTION
Menu 24.2.2 – System Maintenance – Change Console Port Speed
Console Port Speed: 9600
Press ENTER to Confirm or ESC to Cancel:
Comentários a estes Manuais