ZyXEL Communications Omni 288S Manual do Utilizador descarregar pdf (Página 16)

novaPro32 Routel

Routel set-up

7000991003 Q2

Sauter Systems

The ‘Dial Sequence’ settings determine the way the Routel commands the modem to

re-dial the Supervision PC in case the latter doesn't respond (dial sequence for the

non-connect case).

At this moment, only ‘Sequence 1’ and the first channel is to be used, since the nP32

software does not support more than one modem for the reception of Routel calls.

The default settings as above lead to the following sequence:

1. The Routel will call the Supervision PC 5 times (4 repetitions) at intervals of 2

minutes.

2. Then the Routel will call the Supervision PC 3 times (2 repetitions) at intervals of

10 minutes.

3. Then the Routel will call the Supervision PC 256 times (255 repetitions) at

intervals of 30 minutes.

4. Afterwards, the Routel will not call the Supervision PC until this has called the

Routel again.

This increasing interval is required mainly due to national laws (avoiding blacklisting).

The modem thus needs to lock (blacklist) a phone number that has been dialled

frequently with no success (i.e. at no charge). Please refer to Special Hints below for

more information on this topic.

Adapt the dial sequence to your needs if required.

Adding a line with Repetitions = 0 will case the Routel to repeat this line with the

interval time stated continuously.

Close the ‘Dial Sequence’ dialogue box by pressing ‘OK’.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 33 34

Sem comentários

ZyXEL Communications Omni 288S Manual do Utilizador Página 16