Zyxel-communications U-336SA Manual do Utilizador descarregar pdf (Página 92)

78 Fax Operation

Command Value Description

+FNS="string" Non-standard byte string parameter.

"string": string of hexadecimal coded

octets.

+FPI="string" Local fax station ID string, for polling Rx.

+FPR=n Serial port rate control parameter:

n=0 Automatic DTE rate detection by the

DCE.

n>0 Serial rate is fixed at the value multiplied

by 2400 bps. For example, when n=8, the

DTE rate is equal to 19200 bps (8x2400).

+FPS=n Page transfer status: refer to the +FPTS

Class 2 command in previous sections for

settings.

+FRQ=pgl,cbl Receiving quality threshold parameters:

pgl=

0-64

(HEX

value)

Specify the percentage of good lines (e.g.

with negotiated number of pixels) required

for a page considered acceptable. The

percentage of good lines would be

computed by the equation:

100 x (<lc> - <bl>) / <lc>

lc: total line count as reported in the +FPS:

response.

bl: bad line count as reported in the +FPS:

response.

If the resulting value is less than the value

in <pgl>, the page is unacceptable.

cbl=

0-FF

(HEX

value)

Specify the maximum tolerable number of

consecutive bad lines. If this value is

exceeded for a given page, the DCE shall

consider the page unacceptable.

+FSP=n Enable polling command:

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 160 161

Sem comentários

Zyxel-communications U-336SA Manual do Utilizador Página 92