ZyXEL Communications VES-1012 - Guia do Utilizador descarregar pdf (Página 114)

VES-1000 Series Ethernet Switch

15-2 General, Switch and IP Setup

Figure 15-2 Menu 2 - Switch Setup (VES-1012)

Table 15-2 Menu 2 – Switch Setup

FIELD DESCRIPTION EXAMPLE

Ethernet Port 13 and Port

14 Trunking

Ethernet port trunking is disabled by default. Press [SPACE BAR],

select Yes, and then press [ENTER] to allow trunking (make sure the

remote switch also supports trunking).

Enable trunking (press [SPACE BAR], select Yes) only if you connect

both Ethernet ports to a single switch (VES-1008A Ethernet ports 8

and 9 are equivalent to Ethernet ports 13 and 14 in the VES-1012).

Edit Spanning Tree

Protocol

Press [SPACE BAR] once to select Yes and then [ENTER] to display

Menu 2.1 - Spanning Tree Protocol Setup.

Edit GARP Timer Press [SPACE BAR] once to select Yes and then press [ENTER] to

go to Menu 2.2 — GARP Timer Setup.

VLAN Type Press [SPACE BAR] and then press [ENTER] to choose from 802.1Q

or Port-Based. To enable IEEE 802.1Q on the VES, you must

configure it for the switch in this menu, menu 6 port submenu(s) and

menu 17 VLAN setup. Menu 17 is not applicable (N/A) if you choose

port-based VLANs for the switch in menu 2.

802.1Q

IGMP Snooping Press [SPACE BAR] once to select Enable and then press [ENTER].

Press [ENTER] again at the message “Press ENTER to Confirm…“ to

activate IGMP snooping on the device.

Disable

Edit QoS Support Press [SPACE BAR] once to select Yes and then press [ENTER to

go to Menu 2.3 — QoS Setup.

Aging Time Setting Enter a time from 0 to 1700 seconds. This is how long all dynamic

MAC addresses remain in the MAC Address Table before they age

out (and must be relearned).

300

Port Mirroring Port Mirroring allows you to copy traffic from a VDSL port to an

Ethernet port in order that you can examine the VDSL traffic from the

Ethernet port.

Press [SPACE BAR] once to select Enable and then press [ENTER

to allow port mirroring. Select the port that examines this “snooped”

port and the port you want to sniff in the next two fields.

Both the Ethernet port and the VDSL port must be in the same VLAN.

Disable

Snoop Port Press [SPACE BAR] to cycle through the choices and then press

[ENTER] to select an Ethernet port that will monitor a VDSL port.

Menu 2 - Switch Setup

Ethernet Port 13 and Port 14 Trunking= No

Edit Spanning Tree Protocol= No

Edit GARP Timer= No

VLAN Type= 802.1Q

IGMP Snooping= Disable

Edit QoS Support= No

Aging Time Setting= 300

Port Mirroring= Disable

Snoop Port= N/A

Monitored Port= N/A

Broadcast Storm Control= 32 Frames

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 226 227

Comentários a estes Manuais

Sem comentários

ZyXEL Communications VES-1012 - Guia do Utilizador Página 114

Comentários a estes Manuais

Manuais e produtos relacionados com Redes ZyXEL Communications VES-1012 -