ZyXEL Communications VES-1012 - Guia do Utilizador descarregar pdf (Página 167)

VES-1000 Series Ethernet Switch

Firmware and Configuration File Maintenance 21-13

2. After the "Starting Xmodem upload" message appears, activate the Xmodem protocol on your computer.

Follow the procedure as shown previously for the HyperTerminal program. The procedure for other serial

communications programs should be similar.

3. Enter “atgo” to restart the VES.

21.4.11 Example Xmodem Configuration Upload Using

HyperTerminal

Click Transfer, then Send File to display the following screen.

Figure 21-19 Example Xmodem Upload

After the configuration upload process has completed, restart the VES by entering “atgo”.

21.5 Upload the Default Configuration File

You can upload the default configuration file using the “sys loadrom” line command:

Figure 21-20 Upload Default Configuration File

The console speed changes to 9600 bps, the IP address to 192.168.1.1, the subnet mask to 255.255.255.0 and all

custom settings revert to the default value. Enter “y” and then [ENTER] to begin uploading the default

configuration file. You see the next screen.

Type the configuration file’s

location, or click Browse to search

for it.

Choose the Xmodem protocol.

Then click Send.

ras> sys loadrom

Default Romfile reset...

System Restart (Console speed will be changed to 9600 bps)

IP will be changed to 192.168.1.1

IP mask will be changed to 255.255.255.0

All previous setting will be set to the default value.

Would you like to proceed?(y/n)

1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 226 227

Sem comentários

ZyXEL Communications VES-1012 - Guia do Utilizador Página 167