ZyXEL Communications VES-1012 - Guia do Utilizador descarregar pdf (Página 63)

VES-1000 Series Ethernet Switch

Static Route 7-3

Table 7-2 Static Route Edit

LABEL DESCRIPTION

Name Enter the name of the static route.

Active Select the check box to turn this static route on when you apply it.

Destination IP

Address

This parameter specifies the IP network address of the final destination. Routing is always

based on network number. If you need to specify a route to a single host, use a subnet

mask of 255.255.255.255 in the subnet mask field to force the network number to be

identical to the host ID.

IP Subnet Mask Enter the subnet mask for this destination.

Gateway IP

Address

Enter the IP address of the gateway. The gateway is an immediate neighbor of your line

card that will forward the packet to the destination. The gateway must be a router on the

same segment as your line card.

Metric The metric represents the cost of transmission for routing purposes. IP routing uses hop

count as the measurement of cost, with a minimum of 0 for directly connected networks.

Enter a number that approximates the cost for this link. The number need not be precise,

but it must be between 0 and 15. In practice, 2 or 3 is usually a good number.

Apply Click Apply to save your changes.

Cancel Click Cancel to begin configuring this screen afresh.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 226 227

Sem comentários

ZyXEL Communications VES-1012 - Guia do Utilizador Página 63