ZyXEL Communications VES-1012 - Guia do Utilizador descarregar pdf (Página 115)

VES-1000 Series Ethernet Switch

General, Switch and IP Setup 15-3

Table 15-2 Menu 2 – Switch Setup

FIELD DESCRIPTION EXAMPLE

Monitored Port Press [SPACE BAR] to cycle through the choices and then press

[ENTER] to select a VDSL port that will be monitored.

Broadcast Storm Control Use this field to limit the number of broadcast frames that can be

stored in the switch buffer. Broadcast frames that arrive when the

buffer is full are discarded. Press [SPACE BAR] to cycle through the

choices (16, 32, 48 or 64 frames) and then press [ENTER]. If you

wish your network to receive a lot of broadcast traffic then choose a

larger number. To reduce broadcast traffic coming into your network,

choose a smaller number.

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to save your

configuration, or press [ESC] at any time to cancel.

15.2.1 Configuring STP on the VES

To configure STP on the VES, select 2 from the main menu, go to the Edit Spanning Tree Protocol field, press

[SPACE BAR] once to select Yes and then [ENTER] to display Menu 2.1 - Spanning Tree Protocol Setup

menu.

Figure 15-3 Menu 2.1 Spanning Tree Protocol Setup

Table 15-3 Menu 2.1 - Spanning Tree Protocol Setup

FIELD DESCRIPTION EXAMPLE

Spanning Tree

Protocol

Press [SPACE BAR] to toggle between Enable and Disable.

Disable

Bridge Priority Bridge priority is used in determining the root device, root port and designated

port. The device with the highest priority (lowest numeric value) becomes the

STP root device. If all devices have the same priority, the device with the lowest

MAC address will then become the root device. The allowed range is 0 to 65535.

The lower the numeric value you assign, the higher the priority for this bridge.

32768 (default)

Bridge Hello

Time(sec)

This is the time interval in seconds between configuration message generated

by the root device. The allowed range is 1 to 10 seconds.

2 (default)

Menu 2.1 - Spanning Tree Protocol Setup

Spanning Tree Protocol= Disable

Bridge Priority= 32768

Bridge Hello Time(sec)= 2

Bridge Max Age(sec)= 20

Forward Delay(sec)= 15

Press ENTER to Confirm or ESC to Cancel:

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 226 227

Comentários a estes Manuais

Sem comentários

ZyXEL Communications VES-1012 - Guia do Utilizador Página 115

Comentários a estes Manuais

Manuais e produtos relacionados com Redes ZyXEL Communications VES-1012 -