ZyXEL Communications P-660 series Guia do Utilizador descarregar pdf (Página 143)

Chapter 10 Static Route

P-660R-F1 Series User’s Guide

143

10.2.1 Static Route Edit

Select a static route index number and click Edit. The screen shown next appears. Use this screen

to configure the required information for a static route.

Figure 87 Static Route Edit

The following table describes the labels in this screen.

Table 54 Static Route Edit

LABEL DESCRIPTION

Active This field allows you to activate/deactivate this static route.

Route Name Enter the name of the IP static route. Leave this field blank to delete this static

route.

Destination IP

Address

This parameter specifies the IP network address of the final destination. Routing is

always based on network number. If you need to specify a route to a single host,

use a subnet mask of 255.255.255.255 in the subnet mask field to force the

network number to be identical to the host ID.

IP Subnet Mask Enter the IP subnet mask here.

Gateway Type Use either Gateway Address or Gateway Node to configure a static route.

Gateway IP

Address

This field is available when you select Gateway Address from Gateway Type.

Enter the IP address of the gateway. The gateway is a router or switch on the same

network segment as the device's LAN or WAN port. The gateway helps forward

packets to their destinations.

Gateway Node This field is available when you select Gateway Node from Gateway Type.

Select a remote node to set the static route. A remote note is a connection point

outside of the local area network. One example of a remote node is your

connection to your ISP.

Back Click Back to return to the previous screen without saving.

Apply Click Apply to save your changes back to the ZyXEL Device.

Cancel Click Cancel to begin configuring this screen afresh.

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 267 268

Sem comentários

ZyXEL Communications P-660 series Guia do Utilizador Página 143