ZyXEL Communications P-660 series Guia do Utilizador descarregar pdf (Página 58)

Chapter 4 WAN Setup

P-660R-F1 Series User’s Guide

4.7 Traffic Redirect

Traffic redirect forwards traffic to a backup gateway when the ZyXEL Device cannot connect to the

Internet. An example is shown in the figure below.

Figure 29 Traffic Redirect Example

Sustain Cell Rate The Sustain Cell Rate (SCR) sets the average cell rate (long-term) that can be

transmitted. Type the SCR, which must be less than the PCR. Note that system

default is 0 cells/sec.

Maximum Burst

Size

Maximum Burst Size (MBS) refers to the maximum number of cells that can be

sent at the peak rate. Type the MBS, which is less than 65535.

Packet Filter

Incoming Filter

Sets

Protocol Filter Select the protocol filter(s) to control incoming traffic. You may choose up to 4

sets of filters.

You can configure packet filters in the Packet Filter screen.

Generic Filter Select the generic filter(s) to control outgoing traffic. You may choose up to 4 sets

of filters.

You can configure generic filters in the Packet Filter screen.

Outgoing Filter

Sets

Protocol Filter Select the protocol filter(s) to control outgoing traffic. You may choose up to 4

sets of filters.

You can configure protocol filters in the Packet Filter screen.

Generic Filter Select the generic filter(s) to control outgoing traffic. You may choose up to 4 sets

of filters.

You can configure generic filters in the Packet Filter screen.

Back Click Back to return to the previous screen.

Apply Click Apply to save the changes.

Cancel Click Cancel to begin configuring this screen afresh.

Table 16 More Connections Advanced Setup (continued)

LABEL DESCRIPTION

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 267 268

Sem comentários

ZyXEL Communications P-660 series Guia do Utilizador Página 58