ZyXEL Communications P-660 series Guia do Utilizador descarregar pdf (Página 53)

Chapter 4 WAN Setup

P-660R-F1 Series User’s Guide

Sustain Cell Rate The Sustain Cell Rate (SCR) sets the average cell rate (long-term) that can be

transmitted. Type the SCR, which must be less than the PCR. Note that system

default is 0 cells/sec.

Maximum Burst

Size

Maximum Burst Size (MBS) refers to the maximum number of cells that can be

sent at the peak rate. Type the MBS, which is less than 65535.

Zero

Configuration

This feature is not applicable/available when you configure the ZyXEL Device to

use a static WAN IP address or in bridge mode.

Select Yes to set the ZyXEL Device to automatically detect the Internet

connection settings (such as the VCI/VPI numbers and the encapsulation method)

from the ISP and make the necessary configuration changes.

Select No to disable this feature. You must manually configure the ZyXEL Device

for Internet access.

PPPoE

Passthrough

(PPPoE

encapsulation

only)

This field is available when you select PPPoE encapsulation.

In addition to the ZyXEL Device's built-in PPPoE client, you can enable PPPoE pass

through to allow up to ten hosts on the LAN to use PPPoE client software on their

computers to connect to the ISP via the ZyXEL Device. Each host can have a

separate account and a public WAN IP address.

PPPoE pass through is an alternative to NAT for application where NAT is not

appropriate.

Disable PPPoE pass through if you do not need to allow hosts on the LAN to use

PPPoE client software on their computers to connect to the ISP.

Packet Filter

Incoming Filter

Sets

Protocol Filter Select the protocol filter(s) to control incoming traffic. You may choose up to 4

sets of filters.

You can configure packet filters in the Packet Filter screen.

Generic Filter Select the generic filter(s) to control outgoing traffic. You may choose up to 4 sets

of filters.

You can configure generic filters in the Packet Filter screen.

Outgoing Filter

Sets

Protocol Filter Select the protocol filter(s) to control outgoing traffic. You may choose up to 4

sets of filters.

You can configure protocol filters in the Packet Filter screen.

Generic Filter Select the generic filter(s) to control outgoing traffic. You may choose up to 4 sets

of filters.

You can configure generic filters in the Packet Filter screen.

Back Click Back to return to the previous screen.

Apply Click Apply to save the changes.

Cancel Click Cancel to begin configuring this screen afresh.

Table 13 Advanced Internet Connection Setup (continued)

LABEL DESCRIPTION

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 267 268

Comentários a estes Manuais

Sem comentários

ZyXEL Communications P-660 series Guia do Utilizador Página 53

Comentários a estes Manuais

Manuais e produtos relacionados com Routers ZyXEL Communications P-660 series