ZyXEL Communications P-660 series Guia do Utilizador descarregar pdf (Página 54)

Chapter 4 WAN Setup

P-660R-F1 Series User’s Guide

4.6 Configuring More Connections

This section describes the protocol-independent parameters for a remote network. They are

required for placing calls to a remote gateway and the network behind it across a WAN connection.

When you use the WAN > Internet Connection screen to set up Internet access, you are

configuring the first WAN connection.

Click Network > WAN > More Connections to display the screen as shown next.

Figure 26 More Connections

The following table describes the labels in this screen.

Table 14 More Connections

LABEL DESCRIPTION

# This is the index number of a connection.

Active This display whether this connection is activated. Clear the check box to disable

the connection. Select the check box to enable it.

Name This is the descriptive name for this connection.

VPI/VCI This is the VPI and VCI values used for this connection.

Encapsulation This is the method of encapsulation used for this connection.

Modify The first (ISP) connection is read-only in this screen. Use the WAN > Internet

Connection screen to edit it.

Click the edit icon to go to the screen where you can edit the connection.

Click the delete icon to remove an existing connection. You cannot remove the

first connection.

Apply Click Apply to save the changes.

Cancel Click Cancel to begin configuring this screen afresh.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 267 268

Sem comentários

ZyXEL Communications P-660 series Guia do Utilizador Página 54