ZyXEL Communications IES-1248-51 Guia do Utilizador Página 230

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 229
Chapter 30 2684 Routed Mode
IES-1248-51V User’s Guide
230
identified by VPI 8 and VCI 35. The CPE device’s WAN IP address is
192.168.10.200. The routed domain is the LAN IP addresses behind the CPE
device. The CPE device’s LAN IP address is 10.10.10.10 and the LAN computer’s IP
address is 10.10.10.1. This includes the CPE device’s LAN IP addresses and the IP
addresses of the LAN computers.
Figure 106 2684 Routed Mode Example
Note the following.
The CPE device’s WAN IP (192.168.10.200 in this example) must be in the same
subnet as the gateway’s IP address (192.168.10.102 in this example).
The IES-1248-51V's management IP address can be any IP address, it doesn't
have any relationship to the WAN IP address or routed gateway IP address.
The IES-1248-51V’s management IP address should not be in the same subnet
as the one defined by the WAN IP address and netmask of the subscribers
device. It is suggested that you set the netmask of the subscriber’s WAN IP
address to 32 to avoid this problem.
The IES-1248-51V's management IP address should not be in the same subnet
range of any RPVC and RPVC domain. It will make the IES-1248-51V confused if
the IES-1248-51V0 receives a packet with this IP as destination IP.
The IES-1248-51V’s management IP address also should not be in the same
subnet as the one defined by the LAN IP address and netmask of the
subscriber’s device. Make sure you assign the IP addresses properly.
In general deployment, the computer must set the CPE device’s LAN IP address
(10.10.10.10 in this example) as its default gateway.
The subnet range of any RPVC and RPVC domain must be unique.
30.2 2684 Routed PVC Screen
Use this screen to configure PVCs for 2684 routed mode traffic.
Vista de página 229
1 2 ... 225 226 227 228 229 230 231 232 233 234 235 ... 653 654

Comentários a estes Manuais

Sem comentários