ZyXEL Communications IES-1248-51 Guia do Utilizador Página 574

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 573
Chapter 70 Troubleshooting
IES-1248-51V User’s Guide
574
70.16 Resetting the Defaults
If you lock yourself (and others) from the IES-1248-51V, you will need to reload
the factory-default configuration file. Uploading the factory-default configuration
file replaces the current configuration file with the factory-default configuration
file. This means that you will lose all previous configurations and the speed of the
console port will be reset to the default of 9600bps with 8 data bit, no parity, one
stop bit and flow control set to none. The user name will be reset to “admin” and
the password will be reset to “1234” and the IP address to 192.168.1.1.
70.16.1 Resetting the Defaults Via Command
If you know the password, you can reload the factory-default configuration file via
Command Line Interface (CLI) command. Use the following procedure.
1 Connect to the console port using a computer with terminal emulation software.
See chapters 2-6 for details.
2 Enter your password.
3 Type config restore.
4 Type y at the question “Do you want to restore default ROM file(y/n)?”
5 The IES-1248-51V restarts.
The IES-1248-51V is now reinitialized with a default configuration file including
the default user name of “admin” and the default password of “1234”.
70.16.2 Uploading the Default Configuration File
If you forget your password or cannot access the IES-1248-51V, you will need to
reload the factory-default configuration file. Uploading the factory-default
configuration file replaces the current configuration file with the factory-default
configuration file. This means that you will lose all previous configurations and the
speed of the console port will be reset to the default of 9600bps with 8 data bit, no
parity, one stop bit and flow control set to none. The password will also be reset to
“1234” and the IP address to 192.168.1.1.
Figure 271 Resetting the Switch Via Command
ras> config restore
System will reboot automatically after restoring default configuration.
Do you want to proceed(y/n)? >
restoring configuration...
saving configuration to flash...
Vista de página 573
1 2 ... 569 570 571 572 573 574 575 576 577 578 579 ... 653 654

Comentários a estes Manuais

Sem comentários